Direct Answer
Inspect sampled fans after complete assembly. Check guard fit and fastening, blade condition and clearance, head and pole connections, base support, height adjustment, control access and stability on a level surface. Any formal safety or compliance test must follow the applicable requirement for the selected market and model.
Inspect Parts Before Assembly
Check the blade, front and rear guards, base, stand, pole, fasteners and adjustment parts for deformation, cracks, sharp damage or missing items. Packing pressure can affect large plastic or wire components.
Match the parts to the approved model and accessory list. Similar cartons can contain different hardware sets when several fan structures are produced together.
Verify Guard Fit and Fastening
Confirm that the guards align, attach using the intended method and remain secure during normal operation. Inspect the center badge and visible finish against the approved appearance.
Do not force mismatched guards into place for inspection. Difficult assembly may become a dealer complaint even if the fan later operates.
Check Blade Condition and Clearance
The blade should be the approved type, free from visible damage and installed in the correct orientation. Rotate or operate the fan under the agreed test condition to screen for contact with the guard or internal obstruction.
If contact, wobble or repeated noise appears, isolate the unit and investigate the blade, shaft, fastening and guard alignment before release.
Review Pole, Height and Head Adjustment
For stand fans, assemble the full pole and test the adjustment and locking points. Confirm that the head remains in the selected position and that user-operated parts are accessible.
For 3-in-1 or convertible structures, verify every approved configuration using the supplied parts and instructions. A claim of multiple uses should be supported by actual assembly.
Assess Base Support and Stability
Place the assembled fan on a level surface and operate it through the relevant speeds and oscillation. Observe movement, rocking and the effect of cord position.
Stability is influenced by correct assembly and surface condition. Record the test setup and avoid making universal claims beyond the selected model's approved requirements.
Link Structural Findings to Packing
Bent guards, scratched poles or cracked bases may originate in internal packing, carton compression or handling. Separate production defects from packing damage so the corrective action addresses the real cause.
Repeat the packing trial after any structural or carton change. A model that passes at the line can still fail after transport simulation or shipment handling if protection is weak.
Verification Checklist
- All assembly parts present
- Guards aligned and secured
- Blade undamaged and clear
- Fasteners match the model
- Height and tilt adjustments work
- Base supports assembled fan
- Convertible formats verified
- Packing protects large parts
Wholesale Factory Discussion
Yaoyuan Electric supplies electric fans for importers, distributors, appliance dealers, supermarkets and OEM brand customers. MOQ starts from 1000 PCS and must be confirmed by model and configuration. Wholesale only; retail and one-piece orders are not accepted.
Send the model direction, quantity, country, plug, voltage, packing, inspection requirement and destination port for a private discussion. Inspection scope, acceptance criteria and commercial handling must be agreed for the actual order.